Measure flow from pressure

Flow device config

You must enter information about your flow device for the display to calculate GPM from the pressure. This information should be obtained from the data sheet for your specific flow device.

Enter the display menu system and scroll down to Flow Device Config. Center press the joystick to select the option. Use left/right to scroll to the field and center press to select it.

• Brand: Select the manufacture from the drop down list. Some manufacture's use a correction factor for large outlet diameters such as 4". The display will use this correction if required. If the manufacture is not listed, use the Generic selection.

• Outlet Diameter: Select the flow outlet diameter from the drop down list.

• Coefficient: Enter the coefficient for your specific device from the manufacture data sheet.

The display uses this information for every Steam Sender sensor. For GPM to be calculated accurately, each sensor must be connected to the same type of device with the same flow criteria. You cannot mix and match and connect one sensor to a 4" outlet and the other three to 2" outlets. You cannot use an orifice reducer in only one flow device.