Change the node address

Accessing internal controls

Unscrew the sensor cords and pull straight out to remove them. Remove the nuts on the sensor connectors using a 11mm socket.

1. Remove the black endcap by unscrewing the 4 screws.  Screws are self-retaining in the endcap so loosen one halfway until you feel resistance then move to the next.  Continue until they are fully removed.

2. Slide the circuit board out 1/2” to see the dip switch and settings buttons.

Changing the node address

Senders ship with the node number set to 1. Each device must be set to a different number for the display to recognize them separately. Only two stream senders can be used simultaneously.

Use the address dip switch at the right corner of the board to change the address if the sender is a 2nd unit.  

Tip: Use a pointy object like a pen to flip switches easier.

Node address options:

• Node 1 - selector 2 down

• Node 2 - selector 2 up